Page 2
Installation Instructions: AM-642 STOP Converter
Rev. A01
MOUNTING THE AM-642 INTERNALLY
The internally-mounted AM-642 (PDB-00642-01) is available only with AM-6000 or Roadrunner 060
computers in an AM-990 or AM-990 jumbo chassis. For all other configurations you must use the
external subsystem, PDB-00642-00, described later in this document.
Here is an overview of the installation procedure:
1. Open your computer’s chassis and card cage, and remove the back I/O panel.
2. If necessary, remove the internal SCSI cable and replace it with the new one provided.
3. Slide the AM-642 assembly into the card cage and attach it to the new SCSI cable.
4. Route the cables from the AM-642 out the I/O panel to the tape drive.
The following sections describe the procedure in detail.
Electronic Equipment Handling Precautions
While your computer's hardware is exposed and the AC power cord is unplugged, the
components are vulnerable to damage caused by static discharge. Your body and clothing are
capable of storing an electrical charge that can damage or destroy unprotected electronic
components. Before you handle any computer hardware, make certain your work area is properly
protected against static discharge. There are a number of commercially available static protection
devices, like the wrist strap shown below, designed specifically to protect your equipment from
harmful static discharge.
Opening the Computer Chassis
1. Turn off power to the computer and unplug it.
