Finn BarkBlower BB-1208 MS, Parts And Operator'S Manual

Page: 17 / 77

11
9. Check hopper and transition for foreign objects that could injure workers or dam-
age equipment.
10. Check the fluid level in the hydraulic tank. Make sure that the service valve is open
on reservoir. Proper level is midway between the upper and lower indicator mark
on the sight gauge. (See page 29 for oil specification.)
11. Install the discharge hose. Use the short hot-air hose section as the first connec-
tion after the airlock. This will help extend the life of the other hoses. Use the
clamps provided with the machine.
CAUTION
Do not use radiator-type clamps. These clamps may not hold under machine-operating
pressure. Failure to comply could result in minor to moderate personal injury. Failure to
comply could also result in product or property damage.
STARTING PROCEDURE
CAUTION
See safety section of the manual (pages 2 through 4) before operating the machine. Failure
to comply could result in minor to moderate personal injury. Failure to comply could also
result in product or property damage.
1. Place the remote control switch in the OFF position on the control panel.
2. Turn the key clockwise until starter engages and the engine starts.
NOTE: This engine has a safety system that will shut the engine off if the
engine oil pressure drops below 7 psi (48 kPa) or if the water tem-
perature reaches 230ºF (110ºC).
3. Allow engine to warm up for 3 to 5 minutes.
4. Prior to mulch application, move the throttle position to fully open, and allow the governor to
control the engine speed. Refer to page 16, Bark Blower Adjustments, for further informa-
tion on control settings. Governed engine speed should be 2,575 to 2,625 rpm under load.
CREW MEMBERS AND THEIR DUTIES
1. The Operator controls the placement of the mulch by moving and aiming the discharge
hose.
2. The Loader(s) feed material to the machine by using a bucket loader or belt conveyor,
dumping material directly into the hopper.
THE MATERIAL-FEED SYSTEM
The material-feed system on the Bark Blower has been designed to give fast and uniform mechan-
ical feeding. The adjustable feeding rate and the automatic reverse control system allow the use
of varied materials while obtaining maximum production. The system is an integration of the fol-
lowing four subsystems, all of which contribute to efficient material flow: