2.
After washing towel your hair and then use the dryer.Plug in appliance and
select the switch position for the right temperature and airflow.
3.
Once your hair is dry set the switch off “0” position and unplug the dryer.
4.
Important
1.
Connect the dryer to 220-240 volt outlet.
2.
Never use in the bathtub,shower,or over a filled sink.
3.
Do not use cleaning solutions or abrasives for cleaning the hair dryer.
4.
Never lay it down on a humid pillow or blanket when in use.
5.
Make sure that the air inlet and air exit grills are free when using the
unit.The dryer is protected against overheating.If the air inlet is accidently
covered,the dryer will stop automatically.Switch off and allow to cool down
for a few minutes before attempting to restart.
6.
Disconnect after use.
7.
Children are not aware of potential hazards.Do not allow children to operate
this appliance.Make sure they are under supervision whenever they use the
hair dryer.
Cleaning your dryer
Please always disconnect your dryer before cleaning.
Do not immerse in water.Protect your dryer unit against dust or oil.From time
to time remove dust and hair from the air inlet grill with a small brush.You can
clean your appliance with a slightly damp cloth and dry it up with a dry cloth
provided the hair dryer is disconnected from the mains supply first.
Warning:
1.
This appliance is not intended for use by persons(including children)with
reduced physical,sensory or mental capabilities,or lack of experience and
knowledge,unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
2.
Children should be supervised to ensure that they do not play with the
appliance.
3.
Do not use this appliance near water in bathtubs,basins or other vessels.
4.
When the hair dryer is used in a bathroom,unplug the appliance after use
since the proximity of water presents a hazard,even when the hair dryer is
switched off.
5.
Do not pull the cord with unnecessary force.Do not damage or modify the
cord,if the supply cord is damaged ,it must be replaced by the
manufacturer,its service agent or a similarly qualified person in order to
avoid a hazard.
6.
Correct disposal of this product.
