Finlux FR-CF100DA+W, Instructions For Use And Maintenance Manual

Page: 13 / 16

EN-5
- 5 -
DEFROSTING THE FREEZER
To save energy, we recommend routine removal of excess frost (3-4 mm) from the inside of the equip-
ment and the cooling grids. Never use sharp or pointed objects or metal tools, humidifiers or heaters,
hairdryers or anti-freeze sprays to do this job. They could irreparably damage the cooling circuit and be
a source of danger in equipment with R600a. We advise defrosting when the compartment is empty or
only containing a few items of food.
To defrost, proceed as follows:
- turn the thermostat switch to stop;
- take the plug out of the wall outlet or switch off the mains system;
- drain off water via the discharge to a basin;
- when all the frost has melted, take up the water with a sponge or cloth;
- clean and dry the walls;
- put the plug back in at the wall outlet and set the thermostat as desired (see the “Getting to know _
your freezer” section.
MAINTENANCE AND CLEANING
Remove the plug from the wall outlet before proceeding or disconnect the general power switch. To
clean the inside of the equipment and its fittings we suggest using water and vinegar (1 spoon for every
2.5 l water). Never use abrasives, detergent or soap. Clean the door sealings with water and dry care-
fully. Never use a steam cleaner to defrost or clean the equipment. Steam can damage live parts in
the equipment and produce a short-circuit and/or electric shock. Steam also damages plastic parts.
PROLONGED DISUSE
If you go away for long periods, disconnect the equipment from the mains supply, empty, clean the in-
side and leave the door open (to prevent mould and bad odours forming).
TIPS ON FREEZING
Prevent products to be frozen coming into contact with products that are already frozen. Make sure
packets are dry, as this will prevent them from freezing together in a solid block.
- Always prepare food in individual portions, which are quicker to thaw out.
- To freeze the maximum quantity of food indicated on the technical data plate, proceed as follows:
s o p o t t a t s o m r e h t e h t t e S - ition '' Max '' 24 hours before freezing.
- Never freeze food in the baskets as they are only suitable for storage.
- For fast freezing, arrange the packaged food with the biggest surface areas in contact with the inside
walls and then transfer to the storage baskets when freezing is complete. Only open the freezer when
necessary and even then as briefly as possible.
- 26 hours after the start of freezing put the thermostat back to the energy saving setting.
- Small quantities of food (up to 3 kg) may be frozen by placing them directly against the walls
of the freezer.
- 6 -
DRAWBACKS AND REMEDIES
The inside temperature isn’t low enough.
Check that:
- the door is perfectly closed; the thermostat is in the correct position;
- the freezer is not near a heat source;
- the freezer is not installed against the wall and that there is free circulation of air;
- there isn’t excess frost on the cooling grids.
The inside temperature is too low.
Check that:
- the thermostat is in the correct position;
- the
super
switch is off.
The appliance is too noisy
Check that:
- the equipment is level;
- the rear element isn’t touching the back wall;
The equipment isn’t working at all.
Check that:
- the thermostat isn’t set at stop;
- the power supply isn’t off;
- the plug is properly in the wall outlet;
- the power cable isn’t broken (see the section headed IMPORTANT SAFETY WARNINGS). If the
freezer still won’t work properly after carrying out the procedures described above, call the nearest
CUSTOMER SERVICE (indicated on attached slip).
Important: the freezer may produce the following slight noises:
When the freezer is installed in a damp, unheated area, droplets of condensation may form on the external
surfaces, especially with relatively low ambient temperatures and high relative humidity. This phenom-
enon in no way affects the equipment’s efficiency or life cycle.
The manufacturer declines any liability for damage that may directly or indirectly be caused to
persons, property or domestic animals by failure to observe all the indications in the instruction
booklet, and especially the warnings regarding installation, use and maintenance.
The manufacturer also reserves the right to make any modifications deemed technically or commercially
appropriate at any time and under no obligation to give prior notice.