appliance before making coffee, including the funnel, filter and cup, so that the
coffee flavour can not be influenced by the cold parts.
1.
Remove the detachable tank and open the tank cover to fill it with desired water,
the water level should not exceed the “MAX” mark in the tank. Then place the
tank into the appliance properly.
2.
Select the one-cup or two –cup mesh, set stainless steel mesh into metal funnel,
pull the press bar backward, make sure the tube on the funnel aligns with groove in
the appliance, then insert the funnel into the appliance from the “Insert” position
and release the press bar, and you can fix them into coffee maker firmly through
turn it anticlockwise until it is at the “
lock
” position. (See fig. 1).
3.
Place an espresso cup (yourself cup) on removable shelf.
4.
Then connecting the appliance to power supply source. Make sure the steam
control knob is on the “OFF” or “0” position.
5.
Press the ON/OFF switch to “1” position, the red lamp will be illuminated, make
the coffee/hot water selector on the “1” position. Press the steam switch on the “0”
position, when there is water flowing out, close the pump (pressing coffee/hot
water selector on the “0” position) immediately. The purpose of the step is that
pump the water of the tank into the housing.
6.
When the green lamp is illuminated, you should press the coffee/hot water selector
on the “1” position again, there will be hot water flowing out. When the green
lamp is extinguished, close the pump. The pre-heating is finished.
MAKE
ESPRESSO COFFEE
1.
Remove the funnel by turning it in clockwise, .Add ground coffee to steel mesh
with measuring spoon, a spoon ground coffee power can make about a cup of
top-grade coffee, then press the ground coffee powder tightly with the tamper.
2.
Set steel mesh into metal funnel, pull the press bar backward, make sure the tube
on the funnel aligns with groove in the appliance, then insert the funnel into the
appliance from the “Insert” position and release the press bar, and you can fix
them into coffee maker firmly through turn it anticlockwise until it is at the “
lock
”
position. (See fig. 1).
Fig.1
Fig.1
