3
RS
23
2
RS
48
5
485+
485-
485+
485-
485+
485-
485-
485+
GND
TXD
RXD
GND
WD1
WD2
RX+
RX-
RX+
RX-
GND
+12V
BEEP
GLED
RLED
INWD0
INWD1
GND
+12V
RJ45-1
RJ45-2
RJ45-3
RJ45-6
TCP/IP
Installation Guide
Face Recognition System for
Door Access
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations prone to high moisture
or condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting Terminals
•
After measuring the height accordingly and make relevant marking
on the wall, drill the screws into the wall to secure the back plate.
•
Attach the terminal to the back plate and tighten the screws. Refer to
Appendix II for dimensions and measurements of installation.
INSTALLATION TIPS:
A good installation location of Face ID 4
must
1 - Avoid sunlight
2 - Be 2 meters away from any light source
e.g. ceiling direct flourescent light
3 - Suggested 1.2m from the ground level
(meas-ure from ground to the camera)
Step 3
Wiring for Power Supply
Use power cables (black and red) to connect to a linear power sup-
ply with specifications of 12VDC 3A (Marked A).
4 feet / 1.2 meter
(recommended)
© 2015 Timetec Computing Sdn Bhd. All rights reserved • 012015
Door Lock connector. Refer to Appendix I
DC12V3A
Power Supply
3rd party
controller with
26-bits wiegand
output
1. RS485 Single Connection
2. RS485 Network Connection
RS232/RS485
Data Converter
RS232/RS485
Data Converter
W
iegand
OUT
3rd party controller with
26-bits wiegand input
RS232
cable
POWER
SUPPLY (A)
TCP/IP PORT
RS232/RS485 SERIAL PORT
