15
Post In-Line filter(s) including Mineral Filter -
Inline Post Filter(s) - Remove the collet clips from the fitting and using
the quick release, remove the tubing on both sides. (Lift filter off
bracket if easier).
Un-screw the fittings from the end of the inline filter. Dispose of
exhausted filter.
Remove any residual PTFE tap from the male thread of the fittings.
Using the PTFE tape provided with the unit, thread 15-20 wraps of
PTFE tap around the male end of both fittings.
Remove the new inline filter from the packaging and screw the fittings
back in place. Ensure the filter is the correct way by the flow arrow.
Put filter back in place and re-insert the tubing and collet clip and pull
back to ensure inserted correctly.
Turn the Pump back on (if applicable) and carry out 1
st
System Flush
from page 11.
Carefully add membrane back into the housing and carry out the 2
nd
flushing stage on page 12.
Replacing Filters and Membrane
–
Please carry out all steps from the Replacing Filters section and carry
out the 1
st
flushing stage.
Follow the instructions for inserting your membrane on page 11 then
carry out the 2
nd
flushing stage.
Finally, go to 3
rd
(Final) Flushing stage to complete the filter and
Membrane changes.
