12
Replacing your filters-
(Filters only, not membrane)-
Please have some towels and cloths ready as some water will
escape from the unit.
Turn off the water by putting the isolator tap to ‘off’ position (1/4” turn
from on position).
Drain as much water from the unit as possible.
*REMOVE THE MEMBRANE FROM THE HOUSING AND SET
ASIDE UNTIL FILTERS HAVE BEEN CHANGED AND THE UNIT
FLUSHED*
Remove the collet clips from the fitting and using the quick release,
remove the tubing on both sides. (Lift filter off bracket if easier).
Un-screw the fittings from the end of the inline filter. Dispose of
exhausted filter.
Remove any residual PTFE tap from the male thread of the fittings.
Using PTFE tape, thread 15-20 wraps of PTFE tap around the male
end of both fittings.
Remove the new inline filter from the packaging and screw the fittings
back in place. Ensure the filter is the correct way by the flow arrow.
Put filter back in place and re-insert the tubing and collet clip and pull
back to ensure inserted correctly.
Do this for all the filters and carry out 1
st
System Flush from page 9.
Carefully add membrane back into the housing.
Replacing Filters and Membrane
–
Please carry out all steps from the Replacing Filters section and carry
out the 1
st
flushing stage.
Follow the instructions for inserting your membrane on page 9 then
carry out the 2
nd
flushing stage to complete the filter and membrane
changes.
