Protected by one or more US Patents: 8915613; D702,391; D702,390; D700,732; D727,554 S; D727,550 S, D727,551 S
© 2017 FINELITE, INC. ALL RIGHTS RESERVED. Form 98383 V2. 04/17
HP-6 Recessed Flush Diffuser Tech Zone 6" T-Bar
Joiner/Ender
Installation Instructions
Note: All power connections to be installed to local/national codes
by a Certified Electrician.
Finelite, Inc. • 30500 Whipple Road • Union City, CA 94587-1530 • (510) 441-1100 • Fax: (510) 441-1510 • www.finelite.com
2
Step 7
Step 5
Starter
Plug-Together Wiring
Joiner/Ender
Step 6
Joint Sleeves
#10-32 x 5/8" Screws (2)
(provided)
Yoke Brackets (2)
(provided)
IMPORTANT STEP
Pivot Point
Connect plug-together wiring connections.
Slowly swing down backplate.
CAUTION: Do not twist the backplate when swinging down – it will come
out of the support extrusion.
Note that the screws shown are the pivot points, and the backplate can be slid
a few inches either way for ease of access to the driver space.
IMPORTANT STEP:
Secure joint with two yoke brackets (provided) using two #10-32 x 5/8" screws
(provided). When installed correctly these brackets will pull luminaires together to make a tight joint.
CAUTION:
Do not over-tighten.
Step 8
Secure luminaire to T-Bar with #6-20 x 1/2" self drilling sheet metal screws (provided).
T-Bar Bracket
#6-20 x 1/2" Self Drilling
Screws (provided)
Secure to Structure
(by others)
Joiner/Ender
Step 9
Replace backplates by holding them in their original position and pushing the clips back in. Make sure wire connections are
not pinched. (If a 1ft. backplate assembly is near joint, reconnect feed harness to LED board.) Replace diffuser and turn power
on to luminaire. NOTE: If part of a longer run, diffuser will be reinstalled back into original luminaire section as lengths vary.
Starter
Joiner/Ender
Backplate Clips
Diffusers
