Protected by one or more US Patents: 8915613; D702,391; D702,390; D700,732; D727,554 S; D727,550 S, D727,551 S
© 2017 FINELITE, INC. ALL RIGHTS RESERVED. Form 98382 V2. 03/17
HP-6 Recessed Flush Diffuser Tech Zone 6" T-Bar
Starter/Independent
Installation Instructions
Note: All power connections to be installed to local/national codes
by a Certified Electrician.
Finelite, Inc. • 30500 Whipple Road • Union City, CA 94587-1530 • (510) 441-1100 • Fax: (510) 441-1510 • www.finelite.com
1
Step 5
Run power cables through conduit plate and jam nut. Make electrical
connections. Secure conduit onto conduit plate with jam nut, and
reinstall conduit plate carefully not to damage any wiring.
Conduit
Conduit Plate
Jam Nut
Wires
Jam Nut
Conduit Plate
Run power cable through knock-out. Make electrical connection.
Secure conduit on to splice box with jam nut and close conduit plate.
Step 1
Step 3
Remove diffuser and set aside to prevent it from getting dirty or dam-
aged. NOTE: If part of a longer run, diffuser will be reinstalled back
into original luminaire section as lengths vary.
Install T-Bar bracket onto luminaire. Secure with #8-18 x 1/4" screws (provided).
Secure luminaire to structure using tie-wire (by others), as per code.
0 - 10V
Dimming
Scan QR code for
helpful video(s)
Diffuser
T-Bar Bracket
Secure to
Structure
(by others)
#8-18 x 1/4" Self Drilling
Screws (Provided)
Step 2
Configure T-Bar to luminaire size and leave an opening for luminaire as noted above.
Make sure T-Bars are aligned at 90 degrees. Place luminaire on T-Bar.
Starter
Starter
Step 4
Remove conduit plate from luminaire. NOTE: Purple and gray wires
are for Low Voltage Control.
Attach optional splice box to conduit plate by hooking onto splice box
bracket. Insert wires through feed hole.
Splice Box
Conduit Plate
Splice Box
Bracket
Wires
Conduit Plate
Screws
OPTIONAL SPLICE BOX
OPTIONAL SPLICE BOX
4"
6"
Center-to-Center
T-Bar Spacing
9/16" Tech Zone 6"