3
Note
:
To avoid operating problems, please take note of battery polarity before/when inserting any
Alkaline Batteries (permanent damaged could be introduced by inserting the battery in wrong
direction). Use good quality Alkaline Batteries and avoid rechargeable batteries.
1) Pull away the shower proof casing of the thermo-hygro sensor to reveal the two sockets (for the wind
sensor and rain sensor)
2) Connect the attached cables of wind and rain sensors to the corresponding sockets of the thermo-hygro
sensor by clicking them into place. Make sure that rain and wind sockets not swapped when plugging the
phone jacket.
3) Open the base station’s battery cover located at the back of the unit and insert 3 x AA, 1.5V Alkaline
batteries into the battery compartment and close the battery cover
4) Open the battery cover of the thermo-hygro sensor located below the two sockets and insert 2 x AA, 1.5V
Alkaline batteries and close the cover
Every time the thermo-hygro sensor is powered up (for example after a change of batteries), the LED
indicator will light up for 4 seconds. The sensor will transmit weather data within the first 24s, and then the
sensor will start radio controlled time reception. During the RCC time reception period (maximum 5 minutes),
no weather data will be transmitted. The LED indicator will be blinking 5 times once RCC signal were
received. The LED indicator will not light again after RCC reception is successful. Regular RF link will be
established once RCC reception routine is finished.
When the base station is powered up, a short beep will sound and all LCD segments will light up for about 3
seconds before it enters into learning mode to learn the sensors security code. After the learning mode the
base station will start the radio controlled time reception.
Note: DO NOT PRESS ANY KEY
during the first 10 minutes learning period or before radio controlled time is
displayed. After both outdoor weather data and radio controlled time are displayed you can place your remote
sensor outdoors and set your time (if no RCC reception is possible). If there is no temperature reading in the
indoor station, make sure the units are within range of each other or repeat the battery installation procedure.
If a key is pressed before the weather station receives the temperature signal, you will need to follow the
battery installation procedure again.
Please wait minimum 10seconds before re-insert the battery again
to make a proper reset for both transmitter and receiver..
Note :
If a battery change on the transmitter side happened, the base station will be resynchronized to the
transmitter within the next 3 hours. If you want to shorten the receiving data time, the base station has to
re-install the battery so that it can have the new security code learnt right way, however the previous data in
base station will be lost.
Note for Radio Controlled Time WWVB:
The time and date display is based on the signal provided by the highly accurate government operated
atomic clock. WWVB signal reception is on every even hour even the reception is successful. If reception has
been successful, the received time and date will overwrite the manually set time and date.
Note:
LED Indicator
Sensor Sockets
Battery
Compartment
Battery cover
Thermo-hygro Sensor
