FINAL-Modellbau
In den Stöcken 20
GLOBAL JET CLUB Europe
D-34305 Niedenstein
Phone: 0049 5624 922486
© text and photos are property of FINAL-Modellbau - All statements without guarantee.
Seite - page
5
/
7
any problems. You can simply cut off any remains with a sharp knife.
2.
Push rods /linkages:
The ways / lengths and positions of the linkages of the rudders are described below. A Jeti
system with the appropriate receiver was used, deflections of the servos may vary depending
on the transmitter system, so the settings only serve as a guide and recommendation. With
jets in particular rudder deflections are very small, which is why the following principle
always applies: on the servo as close as possible to the pivot point and on the side of the
rudder apply always as far away from the pivot point as possible
!
Ailerons:
Length from center screw to center screw: 88mm
