Page 3
Remove the axle (5024133) and (2) wheels
(5021090) from the carton.
Remove the (2) Hitch Pins (5101065) from the
parts bag.
Slide the axle through the hole in one side of the
axle mount (5095371) and through the corre-
sponding hole on the other side.
Slide the wheels over the axle, making sure the
valve stems are facing outward.
Retain the wheels on the axle with the hitch pins.
Place the pins through the holes at the end of the
axle.
Turn the trailer right side up.
Locate the (4) #10x1/2” Screws (5117234) and the (2) Hose
Wraps (5133276) from the parts bag.
To assemble the hose and spraygun holders.
A phillips head screwdriver is required for this step.
Place a screw through the holes in the hose wrap and bring it up
to the tank. Use the phillips head screwdriver to secure the
holders in place. Tighten so the holders are secure. **Do Not
Over-Tighten**
Wrap the hose and clip in the handgun. Do not use excessive
force when placing the handgun into the clips, as this could
cause breakage.
Your tank comes pre-assembled with the pump,
manifold, bypass, intake assembly, lid w/lanyard,
handgun, handgun hose, handgun hose quick connect
and loom clamp already attached.
To assemble the tongue and frame to the tank. Locate
the (4) 5/16”x5/8” flanged bolts (5034531), (2)
5/16”x2” flanged bolts (5034640), tank
support (5095373), axle support (5095371) and the
preassembled tongue (5278141).
Turn the tank upside down and attach the tank
support with (2) 5034531 bolts, attach the axle
support with (2) 5034531 bolts. Just start the bolts,
do not tighten on either support. Then slide the
tongue assembly into place and using the (2) 5034640
bolts, attach to the tank and tighten. Then tighten the
(4) 5034531 bolts down. Do Not Overtighten.
