Page 5
Step 4
NOTE:
grease wheel bearings before installing wheels.
Insert the axle through the holes in the frame tubes. Then slide an
axle spacer on to the axle, followed by a machine bushing. Slide the
wheel on to the axle, then another machine bushing and secure with
the cotter pin.
Repeat for the other side.
Step 5
Attach the trailer boom mounts to the upright arms of the frame
tubes and secure with square u
-
bolts and hex nuts.
Unfold the outer boom arms. With the boom springs on top, center
the boom between the boom mounts and secure to the boom
mounts with square u
-
bolts and hex nuts.
Now, attach the nozzle harness to the boom with the nozzle
clamps. and the nozzles to the inside of the fold, pointing down.
Starting with the center hose barb tee of the nozzle harness, center
on the boom. Mount the nozzles
30”
apart. Place a clamp half over
the top of the boom tube and another clamp half
below the boom tube, slide the clamp halves together into the
groove in the square part of the nozzle.
Secure the clamps to the boom tube.
Loosely slide a hose clamp on to the feeder hose, connect the
boom feeder hose to the hose barb tee on the nozzle harness
and secure with the hose clamp.
Step 6
Thread the pressure gauge into the port on the manifold. Hand
tight should be sufficient.
Attach the hose wraps to the side of the tank, as shown, with 4
screws.
Finally, thread the lid on to the tank, if not already done.
Make sure all hose clamps are tight.
•
Make sure all hose clamps are tight before testing or spray-
ing for the first time.
•
Connect sprayer lead wire to a fully charged 12V battery to
power the sprayer pump. The towing vehicle battery can be used
or a stand
-
alone 12V battery.
The Sprayer is now ready to TEST w/plain water before actual use**
Step 4
Step 5
Step 6