Page 5
*** The Sprayer should now be ready for use ***
After your boom mount brackets are secured in place.
Bolt the 7-nozzle boom in place with (2) Square
U-Bolts and (4) whiz nuts.
A 1/2” socket or wrench is required for this step.
Try to maintain approximately 18-22 inches above the
items being sprayed, for optimal coverage. This is con-
sidered where the nozzles will mount, at the end of
these brackets.
With the boom secured to the boom mount, the nozzle
harness can now be attached.
Attach the nozzle harness to the boom.
Starting with the center nozzle, center the nozzle har-
ness on the boom and then work out to the ends on
both sides using the nozzle clamps, attach the harness
to the boom as shown in DETAIL Clamp.
Af-
ter
your nozzle harness is attached to the boom,
attach the feeder hose with a hose clamp to the center
nozzle.
Place the hose clamp over the end of the hose loosely.
Slip the end of the hose over the hose barb on the
’CROSS’ fitting on the nozzle harness. Use a twisting
motion, if necessary, to get the hose fully onto each
barb. Bring the hose clamp to the connection point and
tighten securely.
Step 7
Step 8
Step 9
DETAIL Clamp
