Page 3
Locate the axle and (2) wheels from the carton.
Remove the (2) Hitch Pin Clips from the parts bag.
Slide the axle through the hole in one side of the axle
mount and through the corresponding hole on the other
side.
Slide a wheel over the axle, making sure the valve
stem is facing outward.
Retain the wheel on the axle with the hitch pin. Place
the pin through the hole at the end of the axle.
Repeat for other side.
Your tank comes pre-assembled with the pump,
manifold, bypass, intake assembly, lid w/lanyard, handgun,
handgun hose, handgun hose quick connect and loom
clamp already attached.
To assemble the tongue and frame to the tank. Locate the
(4) 5/16”x5/8” Flange Lock Screws, (2) 5/16” x 2” Flanged
bolts, tank support, axle support and the
preassembled tongue.
Turn the tank upside down.
Detail A: Loosely attach the tank support and axle support
with (4) lock screws.
Just start the bolts, do not tighten on either support.
Detail B: Slide the tongue assembly into place and using
the (2) flanged bolts, attach to the tank and tighten. Do Not
Overtighten.
Then tighten the (4) lock screws. Do Not Overtighten.
• A phillips head screwdriver is required for this step
Turn the trailer right side up.
Locate the (4) #10x1/2” Screws and the (2) Hose Wraps from the parts bag.
Place a screw through the holes in the hose wrap and bring it up to the tank. Use
the phillips head screwdriver to secure the holders in place. Tighten so the holders
are secure. **Do Not Over-Tighten**
Wrap the hose and clip in the handgun. Do not use excessive force when placing
the handgun into the clips, as this could cause breakage.
Detail A
Detail B
