Fimco 15-2N-ATV-GS, Owner'S Manual

Page: 3 / 10

Page 3
Assembly Procedure (15-2N-ATV-GS)
After your boom brackets are secured to the tank, turn the
tank assembly over and position it so that the ends of the
brackets extend beyond the back of the tank and hanging
over the edge of the table or flat surface you are assembling
this on.
1/2” socket wrench & wrench is required for this step.
Attach the boom assembly to the boom brackets, making
sure the boom is centered. Secure in place with (2) flanged
hex bolts and (2) flanged hex nuts.
After your boom is attached to the boom brackets, locate the
feeder hose and the (2) hose clamps from the parts bag.
Place the hose clamps loosely over each end of the feeder
hose. Slip the ends of the hose over the hose barbs on both
the y-valve manifold and the barb fitting on the nozzle har-
ness of the boom. Use a twisting motion, if necessary, to get
the hose fully onto each barb. Bring the hose clamps to the
connection point and tighten securely.
NOTE:
Make sure the boom feeder hose does not end up on the
‘outside’ of the spray wand hose, otherwise unwrapping the
spray wand hose from around the tank may be difficult.
You are now ready to mount this unit to an ATV, using
ratchet straps (NOT INCLUDED).
Step 2
*** The Sprayer should now be ready for use ***
Step 3
Screw the lid onto the tank.
Locate the (2) clips and (2) phillips head machine
screws from the parts bag.
A phillips head screwdriver is required for this step
Place a screw through the hole in the clip and bring it
up to the tank, where the embossments for the clips
are (located on the rear side of the tank)
Secure the clip/screw to the tank. Tighten so that the
clip is secure. Do this for each clip.
** DO NOT OVER-TIGHTEN **
The spray wand will snap into the clips once installed.
Do not use excessive force when placing the spray
wand into the clips, as this could cause the clips to
break.
Step 4
Place a hose clamp loosely over each end of handgun hose.
Slip the ends of the hose over the hose barb on the y-valve
manifold and the back of the spray wand. Use a twisting mo-
tion, if necessary, to get the hose fully onto each. Bring the
hose clamps to the connection point and tighten securely.
You are now ready to mount this unit to an ATV, using
ratchet straps (NOT INCLUDED).
Step 5