CODE
QTY
WIDTH
LENGTH
NOTES
444025
1
712
245
ABRASIVE PAD, WHITE COLOUR
442484
1
712
245
ABRASIVE PAD, GREEN COLOUR
437864
1
712
245
ABRASIVE PAD, RED COLOUR
444027
1
712
245
ABRASIVE PAD, BROWN COLOUR
442810
1
712
245
ABRASIVE PAD, BLACK COLOUR
CENTRAL BRUSH HEAD ABRASIVE PAD TYPE (ORBITAL VERSION)
TROUBLESHOOTING
This chapter lists the most common problems linked with the use of the machine. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance centre.
PROBLEM
POSSIBLE CAUSE
SOLUTION
THE MACHINE
DOES NOT START
The main switch is set to “0”.
Make sure that the main switch is in its "I" position,
otherwise turn the key a quarter turn clockwise.
Check that when switched on there are no alarm
messages on the command display.
Stop the machine immediately, and contact a specialised
service centre.
Make sure that the batteries are correctly connected to
each other and that the battery connector is connected to
the electrical system connector.
Correctly connect the batteries to each other (see
“CONNECTING THE BATTERIES TO THE MACHINE’S
ELECTRICAL SYSTEM” on page 15.
Correctly connect the batteries to the machine's electrical
system (see “CONNECTING THE BATTERIES TO THE
MACHINE’S ELECTRICAL SYSTEM” on page 15.
Check the charge level of the batteries.
If the battery charge level is critical, perform a complete
recharge cycle (see paragraph “RECHARGING THE
THE BATTERIES
ARE NOT
CHARGED
CORRECTLY
The connector of the battery charger cable is not properly
inserted in the battery connector.
Connect the battery charger cable connector to the
battery connector again.
The plug on the battery charger's power cable is not
correctly inserted into the electrical outlet.
Check that the battery charger power supply cable plug is
connected to the mains socket.
The characteristics of the mains power supply do not
correspond to those required by the battery charger.
Check that the characteristics in the battery charger plate
are the same as those of the mains supply.
The LEDs of the battery charger blink repeatedly.
Referring to the battery charger use and maintenance
manual, check the meaning of the flashing signals that
the battery charger emits dung the battery recharge
stage.
THE MACHINE
HAS A VERY LOW
WORK AUTONOMY
Check the battery charge level, check the symbol on the
command display.
If the battery charge level is critical, perform a complete
recharge cycle (see paragraph “RECHARGING THE
THE MACHINE
DOES NOT MOVE
The machine does not start.
Read the section “THE MACHINE DOES NOT START”.
The traction motor power cable is not correctly
connected.
Go to the left-hand side of the machine, open the side
carter and connect the traction motor power cable to
the contact located on the motor itself.
ATTENTION:
This operation must be carried out by expert personnel,
trained at the FIMAP assistance centre
The electrobrake located in the traction gearmotor is not
engaged.
Go to the left-hand side of the machine, open the side
carter and turn the lever in the traction gearmotor
clockwise.
There is an issue on the drive pedal.
Contact your nearest service centre.
INSUFFICIENT
DETERGENT
SOLUTION ON THE
BRUSHES
The quantity of detergent solution in the water system is
not sufficient for the work to be carried out.
Check that the amount of detergent solution present in
the machine's water system is sufficient for the work to be
carried out.
Detergent solution filter obstructed.
Check the detergent solution filter isn't obstructed. If it is,
clean it (see “CLEANING THE WATER SYSTEM FILTER”
39