SCRUBBING WITH DRYING
To carry out “SCRUBBING AND DRYING” tasks, proceed as follows:
1. Carry out all the checks listed in the section “PREPARING TO WORK” on page 19.
2. Sit on the driver’s seat.
3. Insert the key (1) into the main switch on the control panel and move the main switch to position "I" by turning the key a quarter turn
clockwise (
Fig.1
).
4. Lower the brush head body by turning the brush head control lever (2) on the rear part of the steering column (
Fig.2
).
5. Lower the squeegee body by turning the squeegee control lever (4) on the rear part of the steering column (
Fig.4
).
6. Press the drive pedal (3) (
Fig.3
) to begin moving the machine.
N.B.:
Once the drive pedal is pressed, the brush head body and the squeegee body will begin to descend into their working positions.
N.B.:
Once the brush head body and the squeegee body have reached their working positions, the relative motors will enter into function,
and the solenoid valve will dispense the detergent solution.
7.
During the first few meters of work, check that the detergent solution coming out is appropriate to the work to be carried out; if not, adjust it
after reading the section “REGULATING THE DETERGENT SOLUTION” on page 23.
8.
The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has finished.
N.B.:
If the drive pedal is released during work, the brush motor and the solenoid valve will stop working, and the suction motor will
continue to operate for a few seconds in order to ensure that all the liquid present in the vacuum hose is extracted.
N.B.:
when filling the solution tank, it is good practice to empty the recovery tank using the special drainage hose.
DRYING
To carry out “DRYING WITHOUT SCRUBBING” tasks, proceed as follows:
1. Carry out all the checks listed in the section “PREPARING TO WORK” on page 19.
2. Sit on the driver’s seat.
3. Insert the key (1) into the main switch on the control panel and move the main switch to position "I" by turning the key a quarter turn
clockwise (
Fig.1
).
4. Lower the squeegee body by turning the squeegee control lever (4) on the rear part of the steering column (
Fig.4
).
5. Press the drive pedal (3) (
Fig.3
) to begin moving the machine.
N.B.:
Once the drive pedal has been pressed, the squeegee body will begin to descend into its working position.
N.B.:
Once the squeegee body has reached its working position, the suction motor will enter into function.
6.
The machine will now work at its maximum efficiency level until the batteries run down.
N.B.:
If the drive pedal is released during the drying operation, the suction motor will continue to operate for a few seconds in order to
ensure that all the liquid present in the vacuum hose is extracted.
ATTENTION: The drying without scrubbing operation should only be carried out if the machine was
previously used to carry out a scrubbing without drying operation.
7.
The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has finished.
N.B.:
If the drive pedal is released during work, the gear motors (on the brush head) and the solenoid valve will stop working.
N.B.:
when filling the solution tank, it is good practice to empty the recovery tank using the special drainage hose.
22