Fimap GL Pro, Use And Maintenance Manual

Page: 22 / 32

CLEANING THE BRUSH HEAD BRUSH (SCRUBBING VERSIONS)
Careful cleaning of the brush guarantees better cleaning of the floor as well as a longer brush head gearmotor lifespan. To clean the brush,
proceed as follows:
1. Move to the rear of the machine, press the uncoupling lever (7) ( Fig.7 ) and open the battery compartment closing carter, using the handle
(8) ( Fig.8 ).
ATTENTION: the following operations must be carried out by qualified personnel. An incorrect connection of the connector may cause a
malfunction of the device.
2. Connect the battery connector to the electrical system connector.
3. Reclose the battery compartment closure carter, make sure that the retainer system is correctly engaged.
4. Activate the machine by pressing the button (9) located on the control panel ( Fig.9 ).
5. Lift the front of the machine from the control panel (
Fig.10
).
6. Pressing the operator presence lever (10) ( Fig.11 ) three times activates the brush uncoupling function.
N.B.: Once the brush uncoupling sequence has started, the symbol “
S
” appears on the control display ( Fig.12 ).
ATTENTION:
during this operation, check there are no people or objects near the machine.
7. Clean the brush under a stream of running water to remove any impurities from its bristles. Check the wear status of the bristles and replace
the brushes if they are excessively consumed (the bristles' protrusion must not be less than 10 mm; this distance is indicated on the brush
by the yellow band). See paragraph “ASSEMBLING THE BRUSH HEAD BRUSH (SCRUBBING VERSION)” on page 14 for information
on replacing the brush.
8. After checking to make sure that the brush is clean, reassemble it.
CLEANING THE RECOVERY TANK FILTERS
In order to clean the filters present inside the recovery tank, do the following:
1. Move to the front of the machine.
2. Remove the recovery tank cover (11) ( Fig.13 ).
3. Remove the floating guard (12) by turning it clockwise ( Fig.14 ).
4. Remove the suction motor filter (13) ( Fig.15 ).
5. Clean the brush under a stream of running water to remove any impurities.
N.B.: Use a spatula or brush to eliminate any dirt that is particularly difficult to remove.
6. Refit the suction motor filter and the floating guard.
7. Remove the squeegee filter (14) ( Fig.16 ).
8. Clean the brush under a stream of running water to remove any impurities.
N.B.: Use a spatula or brush to eliminate any dirt that is particularly difficult to remove.
9. When all the components that have just been washed are dry, carry out the operations just described in reverse to insert them into the
machine.
EMPTYING THE SOLUTION TANK
Proceed as follows to empty the solution tank:
1. Move to the rear of the machine, press the uncoupling lever (7) (
Fig.7
) and open the battery compartment closing carter, using the handle
(8) ( Fig.8 ).
2. Remove the solution tank dumping system tube (15) from its seat ( Fig.17 ).
3. Move to the front left of the machine and insert the machine connector (16) located on the solution tank dumping system tube to the female
connector (17) on the solution tank ( Fig.18 ).
4. When the solution tank is empty, repeat the operations in the reverse order to reassemble all the parts.
CLEANING THE WATER SYSTEM FILTER
In order to clean the water system's filter, do the following:
1. Empty the solution tank, see paragraph “EMPTYING THE SOLUTION TANK” on page 22.
2. Go to the front left of the machine and remove the detergent solution filter cap (17) ( Fig.19 ).
3. Rinse the filter cartridge under a jet of water, and use a brush to eliminate any impurities, if necessary.
4. Once the filter cartridge is clean, repeat the operations in the opposite order to reassemble all the parts.
22