At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1.
If active, turn off the suction motor, press the “SUCTION MOTOR ACTIVATION DEACTIVATION” (1) switch on the control panel (
Fig.1
).
2. Lift the squeegee body, press the “SQUEEGEE CONTROL” pedal (2) at the rear right of the machine (
Fig.2
).
3.
Turn off the machine by pressing the stand-by switch (3) on the control panel (
Fig.3
).
4. Take the appliance to the dedicated dirty water drainage area.
5. Carry out all the procedures listed in the chapter “ROUTINE MAINTENANCE” on page 20, indicated in the column entitled AT THE END
OF THE WORK.
6. Once the routine maintenance operations have been completed, take the machine to the area designated for storage.
ATTENTION:
Park the machine in an enclosed place, on a flat surface, and at a safe distance from any objects that could either damage
it or be damaged due to contact with the machine itself.
7. Secure the machine, see paragraph “MACHINE SAFETY” on page 11.
AT THE END OF THE WORK
Before carrying out any routine maintenance operations, proceed as follows:
1. Take the machine to the maintenance area.
WARNING:
the place designated for this operation must comply with current regulations concerning safety at work and current
environmental protection regulations.
2. Carry out the steps necessary to secure the machine (see chapter “MACHINE SAFETY” on page 11).
ATTENTION:
It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
ROUTINE MAINTENANCE
TYPE OF MAINTENANCE
AT THE
END
OF THE
WORK
DAILY
WEEKLY
LONG
PERIOD
OF NON-
USE
TRANSPORT
DRAINING THE RECOVERY TANK
X
X
X
CLEANING THE SQUEEGEE BODY
X
X
X
CLEANING THE BRUSH HEAD BRUSH
X
X
CLEANING THE RECOVERY TANK FILTERS
X
X
EMPTYING THE SOLUTION TANK
X
X
X
CLEANING THE WATER SYSTEM FILTER
X
X
CLEANING THE VACUUM TUBE
X
X
CLEANING THE RECOVERY TANK
X
X
20
2
1
3
1
2
1
2
3
1
3
4
2
4
5
5
