6
Foot Shell Installation and Removal
The AllPro foot features a unique cosmetic foot shell that is flexible and
durable. Use care in the installation and removal of the foot shell to maintain
its appearance and durability.
NOTE: Never use a sharp edged tool such as a screwdriver to install or remove the
foot shell.
Installation
• Pull the Spectra sock tightly
onto the foot, pulling excess
material proximally to the
ankle to eliminate wrinkling.
• Insert the forefoot into the
foot shell as far as possible.
Set the heel on a supportive
surface with the toe up and
push the shell onto the foot
until the toe is in position.
• Rotate the foot side to side
to allow the foot shell to slide onto
the heel.
• Push foot shell over the heel, or if necessary, insert shoehorn into foot
shell and allow heel to slide down shoehorn into the heel lock.
IMPORTANT: The heel of the wave spring must slide into the heel lock in the foot shell for
proper alignment and to secure the foot in the foot shell (Figure 4).
Removal
• Place the foot on a flat surface so that the heel is hanging over the edge.
• Apply downward force to the top portion of the foot shell at the heel. The
heel plate should pop out of the heel lock, allowing removal of the foot
shell by hand.
• If foot shell is too tight, a smooth edged shoehorn may be used to
disengage the heel lock.
Figure 4
Heel Lock
Summary of Contents for AllPro Foot
Page 1: ...AllPro Foot Product Manual...
