6
Assembly
5. Behind the Reclaimer side panel and below the gearbox, install the
(2) 5/16”-18 x 7/8” lower drive enclosure bolts with washers and
tighten using a 1/2” wrench. The motor base enclosure may need to
be shifted under the motor to allign the holes.
6. Reinstall the panel and (7) highlighted panel screws and (4) handle
screws and handle which were removed in step 4.
7. Using a 1/2” wrench, tighten the (4) base bolts which were loosened
in step 1.
8. Remove the inner cotter pin from the hopper hinge and slide out the
rode while removing the aluminum spacers and plastic washers.
7
Assembly
9. Remove the (4) top panel screws using a #2 Philips screw driver.
Line up the two gas spring assembly brackets with the holes in the
top panel as shown and reinstall the screws. Be sure the square
cutouts in the gas spring assembly brackets match with the sensor
cutouts on the top panel.
10. Set the hoppers on top of the Reclaimer in the orientation shown.
