26-0027 Issue 12
Remote Indicator
The remote LED terminals (‘Remote LED + / -’) may be used to connect a separate
LED (Pt No. 600-0092). The LED functions are as follows:
•
5ms every 5 seconds: End of Line
•
5ms every 1.3 seconds: Fault
•
350ms every 0.7 seconds: Fire detected by detector
•
Continuous: Fire detected by detector and processed at panel
Note that the LED does not require a resistor.
Technical Data
Dimensions
................................................................. 105mm diameter x 62mm
Operating temperature
................................................................. -10
o
C to +50
o
C
Voltage Ranges
DC Output from Mains Powered Panel ... 25.5 to 35V DC
DC Output from Battery Powered Panel.. 20 to 26V DC
Operating Current
Quiescent ................................................ 114 uA (Typical)
End of line ON if applicable ..................... 50 uA (Typical)
(in addition to Quiescent)
Alarm Sounding – Sounder High ............. 8 mA (Typical)
Alarm Sounding – Sounder Low .............. 3.5 mA (Typical)
Alarm Sounding – Sounder Off ............... 1.5 mA (Typical)
Alarm Activated ....................................... 48.5 mA (Typical)
(in addition to Alarm Sounding)
LED Operation
Detector in Normal State. ........................ Flash at 20 second intervals
Detector at EOL ....................................... Flash at 5 second intervals
Detector in Fault. ..................................... Flash at 1.3 second intervals
Detector Detecting Fire ........................... Flash at 0.7 second intervals
Detector in Fire
(once processed at panel)
Continuous
Loading Units
V3 Panel:
Pro Panel:
Max Loading Units per zone .................... 27 SLU ........ 160 DLU
Sounder High ........................................... 1.5 SLU ....... 8.0 DLU
Sounder Low ........................................... 1.0 SLU ....... 3.5 DLU
No Sounder ............................................. 0.5 SLU ....... 1.5 DLU
Volume Level
Sounder High ........................................... 89+ dB(A)
(@ 1m anechoic, Dual Tone)
Sounder Low ........................................... 65+ dB(A)
Flammability
. ................................................................ UL94-V2
IP Rating
. ................................................................ IP 21C
Part Codes
No Sounder ............................................. 202 0003
With Sounder ........................................... 202 0001
0832
Fike Safety Technology Ltd,
31 Springvale Ind Est,
Cwmbran, UK. NP44 5BD
(Manufactured Date on Product Label)
0832-CPD-1572
0832-CPD-1573
EN54-3 Fire Alarm Device – Sounder
Type A – Indoor Use
EN54-5 Fire Alarm Device – Heat detector
EN54-7 Fire Alarm Device – Smoke detector
Sounder Technical Data: See 26-0747
Technical Support
Contact your supplier for technical support on this product.
Due to the complexity and inherent importance of a life risk type
system, training on this equipment is essential, and commissioning
should only be carried out by competent persons. Fike cannot
guarantee the operation of any equipment unless all documented
instructions are complied with, without variation. This unit complies
with the EMC directive.
Fike’s policy is one of continual improvement and the right to change
a specification at any time without notice is reserved. Whilst every
care has been taken to ensure that the contents of this document are
correct at time of publication, Fike shall be under no liability
whatsoever in respect of such contents. E&OE.
