PAGE / 6
Doc. P/N 8.8128.00.3
Rev. 3 / July, 2020
WARNING: Before attempting to assemble the bursting disc and bursting disc holder, confirm that the seat area of
the bursting disc is designed to fit the bursting disc holder.
1.
Place holder component with female seat on a work surface (See Figures 4, 5 and 6).
Figure 4 - Insert Holder
2.
If the holder was supplied with an optional o-ring groove, install an o-ring into the groove of the component
with the female seat.
Note: Use of an o-ring is for improved sealing and is not required for proper function of the bursting disc
assembly. Do not install an o-ring unless the holder is designed to accept these components by Fike!
3.
Place bursting disc into holder component with female seat with flow arrow on tag pointing in the same
direction as holder component with female seat flow arrow.
Disc Loc
TM
tab, if present, must seat properly in recess.
4.
If the holder was supplied with an optional o-ring groove, install an o-ring into the groove of the component
with the male seat.
Note: Use of an o-ring is for improved sealing and is not required for proper function of the bursting disc
assembly. Do not install an o-ring unless the holder is designed to accept these components by Fike!
Summary of Contents for RD300 Holder
Page 17: ...Notes...
