Series Installation Guide
Approved Document No: 26-1197
Issue: 1 Authorised: Date: 01/8/2013
Wiring Diagram
Note:
Polarity must be observed on detector as indicated on schematic wiring diagram.
Earth terminal is provided to maintain earth screen continuity. It does not connect to this detector head.
Base Installation
Connect the zone wires to the appropriate terminal. Tighten with a correct sized screwdriver: a wrong screwdriver may damage the screw heads.
Make sure that the base contacts are clean and unobstructed.
Note, the base Part No. for OSCELUS Series is 200-0014 or 200-0015
Detector Head Installation
If there is still minor construction work in progress, the head may be fitted, provided that the dust cover is still in place.
To fit the detector, mate the detector onto the base and rotate the detector in a clockwise direction until the detector loads into the base. Continue
to twist clockwise to secure it.
Model
There are 4 models of Fyreye II Conventional Detector.
Monitor state
In monitor state, the two red LEDs on the top cover will blink every 5 seconds. See Fig-1.
Pre-alarm state
In pre-alarm state, LED pairs will blink a clockwise circle in every 5 seconds.
Fire alarm state
In fire alarm state, the two LEDs shown in Fig-1 will light. The other 3-pairs of LED will light for 0.5 seconds rotating
clockwise.
False alarms
In case of false alarm, the LED pairs will blink alternately. Check if the air around the detector is clear. Fan the air
around the smoke alarm if necessary, until the alarm turns off. If the false alarm occurs frequently or continuously,
arrange to have the unit serviced.
Sensitivity Read
Take the Sensitivity Test Wand making the receive diode against the light-emitting diode (see Fig-2).
And push the button of the Sensitivity Test Wand, the sensitivity will be displayed on LCD of Wand for
a few moments later.
Part No
Model No.
Description
CPR No.
LPCB No
200-0010
OSCELUS-OP
Conventional optical detector
200-0011
OSCELUS-HR
Conventional A2R heat detector
200-0012
OSCELUS-HF
Conventional A2S heat detector
200-0013
OSCELUS-OH
Conventional optical and heat detector
Fig-2
Fig-1
