Fike DUONET, User Manual

Page: 18 / 28

Duonet Control Panel User Guide
18
Printer
Duonet control panels can have an optional printer fitted if required. This must be specified when
ordering a panel and cannot be fitted by the end user or installer as an after market addition. If the
printer is fitted it will print out local events as they occur. The local events which get printed will be fires
and/or faults and/or panel events depending on how the engineer has programmed the panel during
commissioning.
Paper out
The printer will automatically detect when the printer paper has run out. The Status indicator LED will
flash repeatedly.
Fitting a new roll of paper
The paper used in the printer is Fike Part No 507-0016. No other paper should be used.
•
The printer paper can be accessed by lifting the front cover on the printer.
•
Use the paper feed button (located on the right hand side opposite the Status indicator LED) to
feed through the last few centimetres of paper.
•
Fit a new paper roll onto the carrier. The printer incorporates an automatic paper feed facility.
With a new paper roll mounted on the carrier and with a clean straight edge to the paper, present
the paper to the entry point behind the rubber roller. The paper will be sensed by the mechanism
and automatically feed through into a position ready for printing.
•
Use the paper feed button to feed more paper through if required.
Specification:
Printing system Thermal line head
Max characters per line 48
Character matrix (dots) 24x16, 24x12 or 24x8
Character size 3x2, 3x1.5 or 3x1mm (Approx. 13, 17 or 25cpi)
Dot pitch horizontal 0.125mm (Approx. 200dpi)
Dot pitch vertical 0.125mm
Text line composition (dots) 24x384
Printing width 48mm
Paper width 58 mm (+0 / -1)