EN
10
FZS 70105-0
Assembly and operation
Checking the remaining capacity of the battery
Press the button (15).
The remaining capacity of the battery is displayed by the control lights (16).
Battery capacity indicator
Press the battery capacity indicator switch. The battery capacity indicator shows the charge status of the battery
using 4 LEDs.
All 4 LEDs are lit:
The battery is fully charged.
3 or 2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery pack is too hot (e.g. due to direct sunshine or prolonged use) or too cold (below 4°C), do not use or
charge the battery pack. make sure the battery temperature to between 40°F(4°C) and 104°F(40°C).
Check before starting the device!
DANGER!
Risk of injury! The device may only be put into operation if there are no defects. If a part is
defective it must be replaced before the device is used again.
WARNING!
Risk of injury! Before starting work check the area and remove all objects which may be kicked
up by the unit.
Check to make sure the device is in safe operating condition:
Check to make sure there are no visible defects.
Check to make sure all device components are correctly mounted.
Proper position
Hold the unit
with the left hand on the front handle,
and the right hand at approximately hip level on the operating handle,
balanced in a comfortable way.
Setting the length of the unit
(See Fig. 7)
Slacken the Shaft Adjustment Collar (5)
Pull the telescopic pole to the desired length.
Retighten the Shaft Adjustment Collar (5) again.
Fig. 7
