EN
10
FZS 2306-E
Winding string trimmer line on to the trimmer head
1. Push in the retaining latches on the side of the
head and take off the cover (see Fig. 5, points
A&B)
2. Remove the coil from the string head. Prepare
about 2 cm of string with 1.4 mm in diameter.
3. Fold the string in half and secure bend in the
groove (see Fig. 5, point C)
4. Then, wind both ends in parallel onto the coil
clockwise. Secure the ends of the wound on
string trimmer line into the prepared holes (see
Fig. 5, point D)
5. Put the coil back in the string head and secure
with the cover (see Fig. 5, point E&F)
WARNING
Use only good quality nylon string trimmer line with
a diameter of 1.4 mm. Never use wire or wire-
reinforced string trimmer line instead of the nylon
string trimmer line. Only use the original string
trimmer head.
B
C
D
E
F
A
Fig. 5
Assembly
Summary of Contents for FZS 2306-E
Page 1: ...EN FZS 2306 E ...
