Fieldmann FZS 1025-A, User Manual

Page: 17 / 84

EN
USER’S MANUAL
17
CORDLESS GRASS TRIMMER
Maintenance
7. MAINTENANCE
Replacing the line spool
WARNING! The trimmer continues to spin after being switched off! Always remove battery before
performing any work on the trimmer!
1. Press the sides of the spool cover as shown and remove it with the spool (Figure M + N + O ). Ensure that you
do not lose the spring.
2. Remove the empty line spool.
3. Thread the ends of the line on the new line spool through the eyelets in the spool cover (fig.
P )
4. Fit the spool cover and spool back into the spool mounting.
5. The line will be cut to the correct length when the cutting head starts up again.
WARNING! When switched on, thread is cut off to operational length. Only switch machine on when in
operational position.
Faults and how to remedy
Problem Cause Remedy
Tilt switch is not working.
Spool is empty. Fit new spool.
Dirt and debris in spool drive
mechanism.
Clean parts with a brush.
Line is torn and stuck inside spool.
Remove spool, check tightness of
winding and replace spool in the usual
way.
Line is ,welded“ to itself or to spool
through heat build-up.
Remove welded line section, check
tightness of winding and replace spool
in the usual way.
String breaks too
frequently
Coil too dry or brittle.
Place the coil in a container with water
for approx. 24 hours. Dry and reinstall it.
String in contact with fence posts, trees,
etc.
Use plant guard.
When in doubt, always consult a Best service workshop.
WARNING! Switch off the trimmer and disconnect the battery before inspecting, cleaning or working on the
thread.