Fieldmann FZR 5110-B, Manual, Page: 16 / 20

EN 16
FZR 5110-B
Maintenance
If the blade strongly impacts an obstacle, stop the lawnmower and take it to an authorised service centre.
BLADE: the blade is made from pressed steel. To achieve the best possible mowing results, regularly sharpen
the blades, approximately after every 25 hours of operation. Check that the blade is always correctly
balanced. To do this, insert a steel axle (with a diameter of 2-3 mm) into the middle hole. If it is correctly
levelled, the axis will remain in the horizontal position.
If the blade does not remain in the horizontal position, replace it.
When removing the blade, screw out the bolt, check the load bearing part of the blade. If the parts are worn
out or damaged, replace them.
ATTENTION:
Always use only original spare parts. Poor quality spare parts may cause serious damage to
the lawnmower and create a safety hazard.
SERVICE
In the event that after purchasing the product you fi nd any kind of defect, contact the service department.
When using the product, follow the instructions contained in the included user's manual.
A complaint will not be accepted if you modifi ed the product or if you did not follow the instructions in the
user's manual.
WARRANTY DOES NOT COVER
Normal wear and tear of operating parts of the machine as a result of its use
Servicing tasks related to standard maintenance of the machine (e.g. cleaning, lubrication, tuning, etc.).
Defects caused by external effects (e.g. climatic conditions, dustiness, inappropriate use, etc.)
Mechanical damage resulting from the machine being dropped, impact, etc.
Damages resulting from unprofessional handling, overloading, use of incorrect parts, inappropriate tools, etc.
On returned products that were not properly protected against mechanical damage during transport, the risk
of potential damage is borne exclusively by the owner.
STORAGE
If you will not be using the machine for an extended period of time, store it according to the following
instructions. This will extend the lifetime of the machine.
Fully drain fuel from the fuel tank and the carburettor.
Screw out the spark plug and pour a small amount of motor oil into the socket. Gently pull the pull cord 2 to 3
times.
Use a clean cloth to clean the exterior surfaces. Store the machine in a clean dry location.