Fieldmann FZP 2020-E, User Manual

Page: 14 / 120

EN 14
FZP 2020-E
It is not necessary to push the chain saw into the cut. When the motor is running at full speed, push the chain
saw down lightly.
If the chain jams in the cut, do not attempt to free it by pulling, rather stretch open the cut using a wedge or
crowbar.
Safety brake (protection against kickback)
This chain saw is equipped with an automatic chain brake that, if it works correctly, immediately stops the
chain in the event of kickback. It is necessary to check the working order of the chain brake before every use
of the chain saw. Run the chainsaw at full speed for 1 - 2 seconds and then tilt the front protective cover. The
chain must stop immediately even when the motor is running at high speed. If the chain stops slowly or does
not stop at all, please contact an authorised service centre.
It is extremely important to check the working order of the chain brake and the sharpness of the chain before
every use to ensure that the necessary level of safety in the event of a kickback is maintained. Removing
safety accessories, incorrect maintenance or when using unsuitable guide bars or chains may, in the event
of kickback, result in serious injuries.
Cutting trees
Decide about the direction in which the tree will fall, respecting
the wind direction, incline angle of the tree and location of the
branches, and consider all other factors before cutting.
The area around the tree must be clear, without obstacles, and
must enable a stable stance. The escape route must be passable.
Cut a wedge into one third of the tree’s diameter on the side to
which the tree should fall. (see fi g. Cutting trees, point 1)
From the opposite direction perform a separation cut at a level
above the wedge cut. (see fi g. Cutting trees, point 2)
The tree will fall in the direction towards the wedge cut.
(see fi g. Cutting trees, point 3)
ATTENTION!
When cutting trees, inform other people in the area about the potential danger. Cutting trees requires
experience and we do not recommend performing this task without the necessary experience.
Cutting logs
ATTENTION!
Always maintain a stable stance. Do not step on logs.
ATTENTION!
Before starting work, check that all components are in their place and that all nuts and bolts are tightened.
The log being cut may roll away. Especially when cutting on a slope, always stand above the log being cut.
Prevent kickback of the saw by following the instructions in chapter “Safety instructions”.
Before starting work, assess the direction of the force causing the cut trunk to bend. The fi nal cut needs to
always be done from the opposite side of where the bending force is acting to prevent the guide bar from
being clamped inside the cut.
Only carry the chain saw with the motor turned off and the guide bar protected by the protective cover.
Cutting
Cutting trees