Fieldmann FZD 4001-E, Instruction Manual

Page: 16 / 108

FZD 4001-E
16 EN Assembly | Operation
6. ASSEMBLY
Assembly Mounting the feet
P. 4, item 2
Screw the feet onto the frame using the M5 × 20 screws and ø 5 mm washers.
Mounting the wheels
P. 4, item 2
Insert the axle into the frame.
Push the ø 10 mm washer onto the axle.
Push the wheel onto the axle.
Push the ø 8 mm washer onto the thread.
Screw the self-locking nut onto the thread and tighten with the spanner provided.
Place the wheel cap on the wheel.
Repeat the procedure for the other wheel.
Mounting the chipper
P. 5, item 3
Position the chipper on the frame as shown and fasten using the M5 × 35 screws
and ø 5 mm washers.
Fasten the hopper (5) to the chipper housing with the locking screw (2).
Push the collection tray (4) into the frame.
7. OPERATION
WARNING!
Check before starting!
WARNING!
Risk of injury!
The product must only be put into operation if no defects are found. It is crucial that any
defective parts are replaced before the product is used again.
Check the safety equipment and the safe condition of the product:
Check whether the hopper is empty.
Check all parts to make sure that they fit tightly.
Check whether there are any visible defects: broken parts, cracks, etc.
Starting the product
P. 6, item 4
P. 6, item 5