Fieldmann FDUB 70605-0, Manual, Page: 10 / 80

EN 10
FDUB 70605-0
Specific safety instructions
Make sure to prevent the sparks from hitting a person or igniting infl ammable goods.
Do network with the grinder if someone is standing in the line of the grinding disc. Make sure to clean up the
working area around you.
Press the locking knob of the disc (3) only after the engine and spindle of the grinder hove completely
stopped !
Remember that the grinding disc will continue to rotate for a while otter switching off the grinder due to
inertia.
Always use the auxiliary handle supplied with the tool. Loss of control over the electric tools could cause
injury.
WARNING! Use means of protection against noise, dust and vibrations !!!
WARNING! Keep these safety instructions !!!
Safety warnings specifi c for Grinding and Abrasive
Cutting-Off operations
Use only wheel types that are recommended for your power tool and the specifi c guard designed for the
selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are
unsafe.
The grinding surface of the centre depressed wheels must be mounted below the plane of the guard lip. An
improperly mounted wheel that projects through the plane of the guard lip cannot be adequately protected.
The guard must be securely attached to the power tool and positioned for maximum safety, so the least
amount of wheel is exposed towards the operator. The guard helps to protect operator from broken wheel
fragments, accidental contact with wheel and sparks that could ignite clothing.
Wheels must be used only for recommended applications. For example: do not grind with the side of the
cut-off wheel. Abrasive cut-off wheels are intended for peripheral grinding; side forces applied to these
wheels may cause them to shatter.
Always use undamaged wheel fl anges that are of correct size and shape for your selected wheel. Proper
wheel fl anges support the wheel thus reducing the possibility of wheel breakage. Flanges for cut-off wheels
may be different from grinding wheel fl anges.
Do not use worn down reinforced wheels from larger power tools. Wheels intended for larger power tools are
not suitable for the higher speed of a smaller tool and may burst.
Additional safety warnings specifi c for abrasive cutting off operations.
Do not “jam” the cut-off wheel or apply excessive pressure. Do not attempt to make an excessive depth of
cut. Overstressing the wheel increa ses the loading and suscepthe tibility to twisting or binding of the wheel
in the cut possibility of kickback or wheel breakage.
Do not position your body in line with and behind the rotating wheel. When the wheel, at the point of
operation, is moving away from your body, the possible kickback may propel the spinning wheel and the
power tool directly at you.
When wheel is binding or when interrupting a cut for any reason, switch off the power tool and hold the
power tool motionless until the wheel comes to a complete stop. Never attempt to remove the cut-off wheel
from the cut while the wheel is in motion otherwise kickback may occur.I nvestigate and take corrective
action to eliminate the cause of wheel binding.
Do not restart the cutting operation in the workpiece. Let the wheel reach full speed and carefully re-enter the
cut. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece.