Fieldmann FDB 2005-E, Instruction Manual

Page: 19 / 102

EN
MULTI FUNCTION TOOL OPERATING INSTRUCTIONS
Using the detail sander attachment | Using the scraper blade
NOTE: Do not use the saw blade to pry the cut-out from the drywall. You will break the blade. If the cut-
out is not easy to pry from the drywall, check to make sure each line is cut completely into th corner of the
rectangle.
5.7 USING THE DETAIL SANDER ATTACHMENT
1. I nstall the sanding pad on the multi-tool as outlined in Fig. 2
2. Install the sandpaper on the sanding pad as outlined in Fig. 3
3. Set the speed control wheel between 4 and MAX as outlined in Fig. 6
4. Turn the switch ON as outlined in Fig. 5
This tool is designed for detail sanding on small surface areas. Place the sandpaper surface of the sanding pad
on the work piece to be sanded. Keep the tool moving to avoid gouging the surface. Use coarse sandpaper and
lower speeds when sanding rough surfaces and for removing previous finishes. Use fine sandpaper and higher
speeds to produce the smoothest surface.
5.8 USING THE SCRAPER BLADE
1. Install the scraper blade on the multi-tool as outlined in Fig. 2, Fig. 1 & 2.
2. Set the speed control wheel to #4 and turn the switch ON as outlined in Fig. 5 & 6.
When using the scraper blade to scrape old finishes or glue from a work piece, place the under the side of the
blade flat on the work piece surface and then lift upward on the rear of the tool to allow the blade to form a very
slight angle with the work piece surface. Feed the blade slowly into the material that is to be removed. Do not
force the tool as slower travel speeds will produce better cutting action and reduce the risk of gouging the work
piece.
When using the scraper blade to cut carpet, place a scrap work piece under the carpet where the cut is being
made. Set the speed to MAX, turn the tool so the scraper blade is at right angles (perpendicular) to the carpet
and the feed the blade into the carpet