Fieldmann 50005070, Manual

Page: 9 / 23

EN
CORDLESS RECIPROCATING SAW USER’S MANUAL
9 General safety instructions
i) Hold the hand power tool only by insulated surfaces intended for gripping since the cutting or the welding
equipment may touch a hidden wire or the power cable of the tool during operation.
3. Personal Safety
a) When using the power tool, be attentive and vigilant, pay maximum attention to the activity you are doing.
Focus on work. Do not use the power tool when tired or under the influence of drugs, alcohol or medication.
Even a moment of inattention when using a power tool may result in a serious personal injury. When working
with power tools, do not drink, eat or smoke.
b) Use protective equipment. Always wear eye protection. Use protective equipment corresponding with the
type of work you are doing. Protective equipment, e.g. a respirator, safety slip-resistant shoes, headwear or
hearing protection in accordance with conditions of work reduce the risk of personal injury.
c) Avoid accidental power tool activation. Do not carry power tools connected to the mains with your finger
on the trigger or the switch button. Before connecting to the mains, check that the switch or the trigger is in
the “off” position. Carrying of power tools with your finger on the switch or inserting the power tool plug into
a socket with a switch being “on” may result in serious injuries.
d) Before switching the power tool, remove all adjustment wrenches and other tools. The adjustment wrench or
a tool that remains attached to the rotating part of the power tool may result in injuries of bystanding people.
e) Always keep stable position and balance. Work only on areas that you can safely reach. Never overestimate
your own strength. Do not use power tools when tired.
f) Dress appropriately. Wear working clothes. Do not wear loose-fitting clothes or jewellery. Be careful not to
allow your hair, clothes, gloves or other parts of your body to get too close to the rotating or hot parts of the
power tool.
g) Connect an equipment for dust extraction. If the power tool may be connected to an equipment for capturing
or extraction of dust, make sure to connect the aforesaid equipment and use it properly.
Use of such equipment may reduce the dust-related risks.
h) Fasten the workpiece firmly. Use a carpentry clamp or a vice to fasten a part intended for machining.
i) Dot not use the power tool, if you are under the influence of alcohol, drugs, medication or other intoxicating or
addictive substances.
j) This equipment is not designed for use by persons (including children) with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they are under supervision or have been
instructed with regard to use of the equipment by a person responsible for their safety. Children must be
supervised to be sure that they do not play with the equipment.
4. Use and Maintenance of the Power Tool
a) Always disconnect the power tool from the mains in case of any trouble during work, before each cleaning or
maintenance, for each relocation and after work. Never use the power tool if it is damaged.
b) Should the power tool start to emit an abnormal noise or odour, stop the work immediately.
c) Do not overload the power tool. The power tool works better and safer if operated in specified rpms.
Use the right power tool designed for your activity. The right power tool works better and safer if being used
for work for which it has been designed.
d) Do not use power tools that cannot be safely switched on and switched off by the switch button.
Use of such tools is dangerous. Defect switches must be repaired in an authorized service centre.
e) Disconnect the power tool from the power source before your start its adjustment, exchange of accessories
or maintenance. This will prevent the risk of accidental starting.