4
2. Properly fit the three point linkage as mentioned above & lock with lynch pin.
6. To get good results from the ridger, shovel should be replaced when its length is
reduced by 2” from its original size.
4. Never turn the tractor to the right or left when the ridger is engaged in the soil.
5. Never reverse the tractor when the ridger is engaged in the soil.
3. In case of scrapper touching the tyne, loosen the scrapper bolt and readjust the
scrapper.
2. Replace the worn out nuts & bolts.
3.2 STORAGE OF MACHINE AFTER WORK
3. MAINTENANCE
3.1 MAINTENANCE INSTRUCTIONS
1. If tyne ridger is new after initial working of first two hours, tighten all nuts & bolts.
If you work with the tyne ridger on stony land, maintenance also increases. Please
follow these rules to get the best results.
2. After every fifty hours and tighten all nuts & bolts. After every fifty hours, open
the bearing hub of tyne ridger & cleanse with diesel oil & pump in new grease.
1. Wash the tyne ridger after work.
3. If tyne ridger has to remain unused for long time then clean it & apply a layer of
used oil for rust prevention.
4. These steps will enhance the life of your tyne ridger.
3.3 LUBRICATION
To grease both tyre hub every week.
4. INSTRUCTIONS FOR DRIVER
1. When tyne ridger is ready for use don’t stand between tyne ridger & the tractor.
3
2.4 SAFETY
Understanding the machine safety labels
The machine safety labels shown in this section
are placed in important areas on your machine to
draw attention to potential safety hazards
On your machine the words DANGER,
WARNING, and CAUTION are used with this
safety-alert symbol. DANGER identifies the most
serious hazards.
The operator’s manual also explains any
potential safety hazards whenever necessary.
Safety-Alert Symbol
Never allow riders on the tractor or implement
unless an additional seat is available.
Be careful when moving around steep gradient to
avoid sharp turn.
Never transport the implement on rough roads
during the night. When operating, avoid sharp
turns that may cause tractor colliding with the
implement.
In order to protect yourself always wear adequate
clothes and shoes during the operations.