Setting Planter Seed Depth
1. Place the planter on a flat level surface. Lower the planter until the two coulter assemblies
item 23, rest on the flat surface. Be certain that main frame and tongue are level.
2. Determine how deep the seed needs to be planted that you are going to plant. i.e.1’’,1-
1/2’’,2’’. We will be setting this planter up at 1-1/2’’ seed depth in this set up.
3. Back out hex bolt, item 90,until the wheel assembly can be raised off the flat surface.
Place a 1-1/2’’spacer under wheel. See figure 12.
4 Turn the hex bolt item 90 back in until contacts item 66 wheel bracket Continue
13
4. Turn the hex bolt, item 90, back in until contacts item 66, wheel bracket. Continue
tightening hex bolt until coulter assembly starts to lift of flat surface. Tighten jam nut, item 91.
Repeat for opposite side. The planter is now set for 1-1/2’’ depth.
Summary of Contents for ATV-CBP
