Page
of 5
4
Make sure the ramp is aligned with the wheels of the equipment being loaded or unloaded.
Always load or unload on a solid, level and stable surface with the vehicle in gear, the
parking/emergency brake on and the engine off.
Use as loading ramp only.
Ramp surfaces must be clean, dry and free from oil or grease, or water.
Maximum
recommended height is 30 inches(76cm).
Inspect ramp before each use. Tighten any loose hardware. Replace any worn or damaged
parts. Replace safety strap if webbing is frayed or worn. Do not attempt to use a ramp that is
damaged in any way. No modification, alteration or deviation to the ramp are authorized by
the manufacturer and shall not be made. Proper care and maintenance of the ramp is
essential to safety.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur.
I
t must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
OPERATION
WARNING:
Make sure the vehicle which you are loading into has the engine
turned off and is in gear or park, with the emergency brake engaged and the wheels
blocked with chocks
.
Step 1: Be sure you are loading on a hard, level and stable surface and that the vehicle you are
loading into is parked with the vehicle in gear/“Park” with the emergency/parking brake
engaged, and the engine is “off”. Place the lip edge of the ramp against the tailgate of the
vehicle. The tailgate should not be more than 30”(76cm) in height or the ramp incline will be
too steep.
Step 2: Secure the ramp to the vehicle using the adjustable strap. After the strap is secure, test the
ramp by pulling backwards on it. Make sure it does not slide back or disengage from the
loading surface.
Step 3: Once the ramp is secure and the area is safe to proceed with loading, move the vehicle to
be loaded between the ramps and center the load between both ramp rails.
Step 4: Proceed with loading the vehicle, make sure that the ramp can sustaining the load and does
