FIELD OF VIEW GeoSnap Pro, User Manual

Page: 10 / 34

© Field of View 2018 GeoSnap Pro User Manual
10 10
LED CODES
The meanings of the LEDs on the GeoSnap board are explained in this section.
•
Blue LED – This LED indicates when the board is powered. When power is sent to the
board, this LED shines solid.
•
Red LED & Green LED – These LEDs indicate the status of the GeoSnap, including startup
status, GPS status, triggering, and camera capture indications.
Startup Sequence
LED Code Meaning
Board is checking for access to the microSD card and writing a default
CONFIG file to the card if a CONFIG file does not already exist. *Note: this
is also the LED code for an SD card error (see below) so if this pattern
persists, check the SD card.
No GPS lock but system is ready to start operating. If the GeoSnap is
configured for fast as possible or time triggering, the first trigger
command will be sent at this point
GPS lock. If the GeoSnap is configured for distance triggering, the first
trigger command will be sent at this point.
Capturing Images
LED Code Meaning
Trigger command sent.
Capture confirmation received from camera.
Shutdown
LED Code Meaning
All data logging has stopped and it is safe to power down the system. This
occurs after pressing and holding the trigger button for approximately 3
seconds.
Errors
LED Code Meaning
MicroSD card error. Occurs when there is no card, the card is not seated
properly, the card is full, or if the log file number exceeds 999.