FIC VT-502, Manual, Page: 57 / 65

VT-502 Mainboard Manual
52
IDE Secondary Master PIO
Allows an automatic or a manual configuration of the PCI secondary IDE
hard disk (master) mode.
The options are: Auto (Default), Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
IDE Secondary Slave PIO
Allows an automatic or a manual configuration of the PCI secondary IDE
hard disk (slave) mode.
The options are: Auto (Default), Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
USB Controller
If you do not use the onboard USB feature, it allows you to disable it.
The options are: Enabled, Disabled (Default).
BIOS Support USB Keyboard
If Enabled is selected in the above feature, this feature will appear.
If your USB devices cannot be detect automatically by the system BIOS or
some driver diskettes came with your USB devices, please set at DOS for
allowing you to install the driver.
The options are: Setup (Default), DOS.
Onboard FDD Controller
When enabled, the floppy diskette drive (FDD) controller is activated.
The options are: Enabled (Default), Disabled.
Onboard UART1
If the serial port 1 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and
COM4 may be needed.
The options are: 3F8/IRQ4 (Default), 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3,
Disabled.
Onboard Serial UART2
If the serial port 2 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and
COM4 may be needed.
The options are: 2F8/IRQ3 (Default), 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4,
Disabled.