Fiberplex TD-1280, User Manual

Page: 9 / 16

TDR ‐ 01 Rear Connect Rack
Complementing the flexibility of the
FiberPlex ‘TD Series’ of fiber optic
modules, the TDR ‐ 01 ‐ AC provides
mounting, power and cable
management for up to 6 modules in a
compact and rugged aluminum 1U rack. With
the TD modules rear facing, connections to the TD
units are made from the rear, inside of the rack
enclosure. The integrated key ‐ hole mounting holes on the
bottom the TD units lock securely on mating studs while a rear
retention bar holds them securely in place. A 6 position wiring
harness and included power adapter provide, not just 9 VDC power,
but a positive earth ground to the modules via 3 position Phoenix™ locking
power connectors. Managing all that cabling and fiber can sometimes be
quite a chore so an extended cabling tray with integrated tie down points are provided to help make your
installation clean.
TDP Front Connect Rack
The TDP provides front of rack
connection, mounting, power,
and cable management for up
to 6 front facing TD modules in
a compact and rugged aluminum 1U
rack. Each of the 16 channels of the modular
TDP front panel can accommodate any Neutrik™ D Series
connector, LC and ST barrel connectors, DB9 connectors, etc. The
unused positions are simply fitted with a blank panel. The integrated key ‐ hole
mounting holes on the bottom of the TD units lock securely on mating studs while a rear retention bar holds
them securely in place. A 6 position power wiring harness and included power adapter provide, not just 9 VDC
power, but a positive earth ground to the modules via 3 position Phoenix™ locking power connectors.
Managing all that cabling and fiber can sometimes be quite a chore, the TDP allows a simple solution to put
maximum capacity and flexibility into a single 1U space.
TD ‐ DINR Din Rail Mounting
The FiberPlex TD ‐ DINR is a specialized Mounting Bracket
intended to mount a single FiberPlex TD ‐ Series unit onto
DIN rail conforming to standard EN 50022 (top hat
sections only). Either 35 x 7.5mm or 35 x 15mm section
DIN rail will be compatible with this device.
Possible mounting configurations are:

Flat mounting, the lower profile but wider rail signature
Or

Edge mounting, the higher profile but narrower rail signature