-press tamper three times briefly;
To include sensor into Z-Wave network, please follow:
-set main controller in learn mode (add device mode);
-make sure sensors casing is closed;
-press tamper three times briefly;
-sensor should be added to device panel. Press tamper three times briefly to wake it up;
STEP 5. Reaction to the magnet.
After including sensor in Z-
Wave network check device’s reed sensor efficiency:
-go to device panel in Z-Wave controller;
-put the magnet near the sensor. The device should change its state in the interface;
-take the magnet away from the sensor. The device should change its state in the interface
again;
-check whether LED is blinking during test.
STEP 6. Loose casing.
Casing in the sensor
shouldn’t be loose. If such situation occurred, please follow:
-check whether casing is closed properly from both sides of the sensor;
-check whether antenna inside the sensor is on its place.
Antenna should be curved and placed near casing.
STEP 7. Contact with service.
If only one of steps above has failed, please contact with Fibaro Servicedesk at:
Summary of Contents for FGK Series
Page 1: ......
