23
IT
ALIANO
ENGLISH
assemble the tools to tighten the
bolts fully, passing alternately from
one bolt to the diagonally opposite
one
use the wheel removal wrench to
lower the vehicle and remove the
jack
At the end of the operation:
take the replaced wheel, reattach
it to the support (E) fig. 24 and
tighten the knob (D)
insert the assembled tool fig. 23
provided with the appropriate
extension (B) fig. 22 on the screw
(A) fig. 22 of the spare wheel
housing manoeuvring device and
turn it clockwise to allow the spare
wheel to be raised until it is fully
seated in the housing under the
floor, checking that the notch on
the device has appeared in the
window on the hook (D) fig. 23
38)
For vehicles with alloy rims, proceed
as follows:
carry out the operations described
above for changing the wheel, until
the punctured wheel is loaded on
the spare wheel lifting device
remove the tool kit from the
tool bag, located in the glove
compartment
the kit includes one bracket, three
special screws and one size 10
hex wrench
stand at the rear of the vehicle
where the spare wheel is located
make sure that all of the cable
for the spare wheel lifting device
has been unrolled, grip the bell
and position it inside the circular
bracket fig. 26
26 F1A0424
tighten the knob onto the screw to
secure the bracket fig. 27
27 F1A0425
rest the bracket on the inside of
the alloy rim fig. 28
28 F1A0426
use the hex wrench to tighten the
three special screws on the nuts
of the bracket fig. 29 and secure
the rim
