STARTING AND OPERATING
117
If it is necessary to keep the trailer hitch and
hitch ball assembly mounted for a long period,
it is possible to filter out the trailer hitch and
hitch ball assembly presence within the
sensor’s field of view. The filtering operation
must be performed only by an authorized
dealer.
LANESENSE — IF EQUIPPED
L
ANE
S
ENSE
O
PERATION
The LaneSense system is operational at speeds
above 37 mph (60 km/h) and below 112 mph
(180 km/h). The LaneSense system uses a
forward looking camera to detect lane markings
and measure vehicle position within the lane
boundaries.
When both lane markings are detected and the
driver drifts out of the lane (no turn signal
applied), the LaneSense system provides a
haptic warning in the form of torque applied to
the steering wheel to prompt the driver to
remain within the lane boundaries. If the driver
continues to drift out of the lane, the LaneSense
system provides a visual warning through the
instrument cluster display to prompt the driver
to remain within the lane boundaries.
The driver may manually override the haptic
warning by applying force to the steering wheel
at any time.
When only a single lane marking is detected
and the driver drifts across the lane marking (no
turn signal applied), the LaneSense system
provides a visual warning through the
instrument cluster display to prompt the driver
to remain within the lane. When only a single
lane marking is detected, a haptic (torque)
warning will not be provided.
NOTE:
When operating conditions have been met, the
LaneSense system will monitor if the driver’s
hands are on the steering wheel and provides
an audible warning to the driver if removed. The
system will cancel if the driver does not return
their hands to the wheel.
T
URNING
L
ANE
S
ENSE
O
N
O
R
O
FF
The LaneSense button is located on
the end of the turn signal stalk,
located on the left side of the steering
column.
To turn the LaneSense system on, push the
LaneSense button once. A “Lane Sense On”
message is shown in the instrument cluster
display.
To turn the LaneSense system off, push the
LaneSense button once.
NOTE:
The LaneSense system will retain the last
system state (on or off) from the last ignition
cycle when the ignition is changed to the ON/
RUN position.
CAUTION!
Park Assist is only a parking aid and it is
unable to recognize every obstacle,
including small obstacles. Parking curbs
might be temporarily detected or not
detected at all. Obstacles located above or
below the sensors will not be detected
when they are in close proximity.
The vehicle must be driven slowly when
using Park Assist in order to be able to stop
in time when an obstacle is detected. It is
recommended that the driver looks over
his/her shoulder when using Park Assist.
4
21_FD_OM_EN_USC_t.book Page 117
