4
.
Continue to hold both buttons and observe the indicator light
.
The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter
.
Release both buttons after the indicator light changes
from slow to rapid
.
5
.
At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING”
button
.
This can usually be found where the hanging antenna wire is attached to the garage
door opener motor
.
Firmly push and release the “LEARN” or “TRAINING” button
.
NOTE:
You have 30 seconds in which to initiate the next step after the “LEARN” button has
been pushed
.
6
.
Return to the vehicle and push the programmed HomeLink button twice (holding the
button for two seconds each time)
.
If the device is plugged in and activated, program-
ming is complete
.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to com-
plete the training
.
7
.
To program the remaining two HomeLink buttons, repeat each step for each remain-
ing button
.
DO NOT erase the channels
.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995
.
1
.
Place the ignition switch to the ON/RUN position
.
2
.
Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink indicator light in view
.
3
.
Push and hold the HomeLink button you want to program while you push and hold
the hand-held transmitter button
.
4
.
Continue to hold both buttons and observe the indicator light
.
The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter
.
Release both buttons after the indicator light changes
from slow to rapid
.
5
.
Push and hold the programmed HomeLink button and observe the indicator light
.
If
the indicator light stays on constantly, programming is complete and the garage door
(or device) should activate when the HomeLink button is pushed
.
6
.
To program the two remaining HomeLink buttons, repeat each step for each remain-
ing button
.
DO NOT erase the channels
.
ELECTRONICS
121
Summary of Contents for 500L 2017
Page 194: ...NOTES 192...
