TURN SIGNAL/LIGHTS/HIGH BEAM LEVER
The multifunction lever, located on the left side of the steering wheel, controls the opera-
tion of the headlights, headlight beam selection, passing light and turn signals
.
NOTE:
The external lights can only be turned on with the ignition in the ON/RUN position
.
Turn Signals
Move the multifunction lever up or down
and the arrows on each side of the instru-
ment cluster flash to show proper opera-
tion of the front and rear turn signal lights
.
NOTE:
If either light remains on and does not
flash, or there is a very fast flash rate,
check for a defective outside light bulb
.
If
an indicator fails to light when the lever is
moved, it would suggest that the indicator
bulb is defective
.
Lane Change Assist
Tap the lever up or down once, without moving beyond the detent, and the turn signal
(right or left) will flash five times then automatically turn off
.
Headlights
Rotate the end of the multifunction lever upward to the first detent for headlight opera-
tion
.
NOTE:
When the headlights are turned on, the Daytime Running Lights will be deactivated
.
Parking Lights
To turn on the parking lights, remove the key or turn the ignition to OFF/LOCK position
and turn on the headlights
.
High Beams
With the low beams activated, pull the multifunction lever towards the steering wheel to
turn on the high beams
.
Pull the multifunction lever toward the steering wheel again to
turn off the high beams
.
Turn Signal/Lights Lever
1 — Headlights
2 — Turn Signals
3 — Flash To Pass
4 — High Beams
OPERATING YOUR VEHICLE
29
