69
6. Return to the vehicle and push the
programmed HomeLink® button twice
(holding the button for two seconds each
time). If the garage door opener/device
activates, programming is complete.
To program the remaining two Home
-
Link® buttons, repeat each step for each
remaining button. DO NOT erase the
channels.
NOTE:
If the garage door opener/device does not
activate, push the button a third time (for
two seconds) to complete the training.
Reprogramming A Single HomeLink® Button
(Rolling Code)
To reprogram a channel that has been previ
-
ously trained, follow these steps:
1. Place the ignition in the ON position.
2. Push and hold the desired HomeLink®
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button proceed
with “Programming A Rolling Code” step
2 and follow all remaining steps.”
Programming A Non-Rolling Code
For programming garage door openers manu
-
factured before 1995:
1. Place the ignition in the ON position.
2. Place the hand-held transmitter 1 to
3
inches (3 to 8 cm) away from the
HomeLink® button you wish to program
while keeping the HomeLink® indicator
light in view.
3. Press and hold the HomeLink® button
you want to program while you press and
hold the hand-held transmitter button.
4. Continue to hold both buttons and
observe the indicator light. The Home
-
Link® indicator will flash slowly and then
rapidly after HomeLink® has received
the frequency signal from the hand-held
transmitter. Release both buttons after
the indicator light changes from slow to
rapid.
5. Press and hold the programmed Home
-
Link® button and observe the indicator
light.
If the indicator light stays on
constantly, programming is complete
and the garage door/device should
activate when the HomeLink® button
is pressed.
To program the two remaining Home-
Link® buttons, repeat each step for
each remaining button. DO NOT erase
the channels.
Reprogramming A Single HomeLink® Button
(Non-Rolling Code)
To reprogram a channel that has been previ
-
ously trained, follow these steps:
1. Place the ignition in the ON position.
2. Press and hold the desired HomeLink®
button until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button, proceed
with “Programming A Non-Rolling Code”
step 2 and follow all remaining steps.
Canadian/Gate Operator Programming
The programming of transmitters in Canada/
United States require the transmitter signals
to “time-out” after several seconds of trans
-
mission.
