10
Before reaching into the water, always unplug the power plugs of all devices in the water.
Compare the electrical data of the power supply with the rating plate on the packaging
or on the device. Make sure that the device is protected by a residual current device
with a maximum rated residual current of 30 mA. Operate the device only at a properly
installed power outlet. Keep the mains plug and all connection points dry! Lay the connec-
tion cable protected so that damage is excluded. Only use cables, installations, adapters,
extension leads or connecting leads with earthing contact approved for outdoor use. Do
not carry or pull the device by the connecting cable! If the cable or housing is defective,
the device must not be operated! If the mains connection cable of the device is damaged,
the device must be disposed of, it is no longer possible to replace the mains connection
cable. If the cable is damaged, dispose of the device. Electrical installations on garden
ponds must comply with international and national building regulations. Never open the
housing of the device or its associated parts unless specifically stated in the instructions
for use.
Never make technical changes to the device, this leads to the immediate
termination of any warranty and warranty claims. Only use original spare parts
and accessories. Repairs should only be carried out by authorized service centers.
Never
operate the device without water flow! Never pump liquids other than water!
For questions and problems, contact an electrician for your own safety!
SETTING UP AND COMMISSIONING
Attention! Never operate the device without prefilter and without water flow!
The device should only be operated horizontally and set up stably on solid ground. The
device must be positioned below the water surface. Connect the manifold with side outlet
to the nozzle tube. To do this, use the adapter pieces and connecting pieces supplied with
the model. Insert the desired fountain nozzle onto the nozzle tube. At the side outlet of
the distributor, you can connect a hose via the reducer and the stepped hose nozzle to
operate gargoyles or a small filter system.
Please note the relevant product videos on
setting up and commissioning
in our Youtube channel:
https://www.youtube.com/user/FIAPGmbH
CLEANING AND MAINTENANCE
Before every cleaning and maintenance, make sure that the device is switched off and
disconnected from the power source.
The filter housing and the running unit must be cleaned at regular intervals. The cleaning
interval depends heavily on the degree of contamination. The degree of contamination can
vary significantly from body to body. First remove the nozzle tube and, if necessary, the
adapter pieces. Then open the filter basket and remove the pump motor. To clean the
rotor and internal parts, turn off the pump cover. The rotor can then be easily pulled out
of the liner and cleaned. Do not use sharp-edged objects such as brushes for cleaning.
Steel brushes, use a soft sponge instead. Stubborn stains such as Limescale deposits
are best removed with the
premium
care
PUMP CLEANSER
. With sufficient
PUMPS
GB
AQUA
ACTIVE MINI SET
