LUXOR Table
Art. 1972/B - 1951 - 1942
1
2
Product description and intended use
• Product description and composition
The LUXOR Table - Art. Code 1972/B - 1951 - 1942 is a Table intended as an item of indoor furniture. It is manufactured from
curved float plate glass. The LUXOR Table was produced at the FIAM ITALIA SPA factory at Via Ancona 1/B, 61010 Tavullia (PU),
Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as LUXOR is designed and built to serve as a Table for indoor use and must therefore be used only for this
purpose and no other.
For more information about the product's intended use please refer to section “
2) SAFETY INSTRUCTIONS
”.
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the LUXOR Table in the original packaging
The LUXOR Table, in its original packaging (2 packs; one for the legs and one for the top), must be transported taking the greatest
care to prevent knocks and shaking. It must be stored indoors in a dry place.
Place the LUXOR Table in the original packaging, in the horizontal position. The arrows on the label on the packaging must be
vertical and pointing upward.
Never place weights or loads in excess of 200 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The LUXOR Table in the original packaging weighs min 170 kg to max 220 kg.
It must therefore be placed on surfaces capable of supporting its weight.
• Removing the packaging - assembly
To remove the original packaging of the LUXOR Table, proceed as follows.
a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the LUXOR Table.
c) Remove the frame of the LUXOR Table from its packaging. At least two people are required for this operation.
d) Remove the top of the LUXOR Table from its packaging and place it on the frame. At least two people are required for this
operation. Wear gloves which assure a good grip on the float glass.
Safety instructions
EN
Summary of Contents for LUXOR 1942
Page 2: ...3 1 2 ...
Page 15: ......
